This lacy boot cuff pattern embodies the ultra feminine look perfectly, with loads of texture, and lace trim. However, the lace can be left off if you prefer a more subtle look.

This pattern does not have specific “Small “Medium” or “Large” instructions, rather it is written to be made to fit your leg specifically.

Pick up the matching hat pattern to make it a set!

This is a paid pattern only

Difficulty:
Easy/Intermediate

Materials Needed:
2.75mm (C) hook, or hook needed to obtain gauge
3.25mm (D) hook, or hook needed to obtain gauge
Approximately 150-200 yards of Bernat Baby Sport in “Baby Taupe”
Yarn needle for weaving in ends
Scissors
14” of ¾” Wyla Sew On Ruffled Lace Trim - Ivory
Sewing needle, and thread for attaching lace

Stitches Used:
ch = chain
sl st = slip stitch
sc = single crochet
dc = double crochet
hdc: half double crochet
FPhdc: front post half double crochet
BPhdc: back post half double crochet
st/sts = stitch/stitches

Additional Terms
hdc in the 3rd loop = Look at the top of the stitch, and locate the sideways “V”, bend the stitch to look at the back and you should see another “V”. You’ll be working into the back loop of that “V”, this is called the 3rd loop. When working in rows this loop will be facing you.

Gauge:
Piece should measure 2.5” high, by 6” long after row 8.

Measurements:
Finished cuffs, un-stretched, are about 7” tall, diameter depends on leg circumference.

Additional Notes:
-ch-2, and ch 3 at beginning of row counts as a stitch
-mark first and last st of row if you find your project is taking off diagonally so you don’t miss those stitches. That is what causes the pattern to distort.
-These boot cuffs are directional. Pay attention to which cuff you are working on or your lacy edge will not be on the correct side.